Mazda CX-5 Service & Repair Manual: General
- General Procedures (Steering)
- Precaution
- Steering Abbreviations
- Steering Features
- Steering SST
- Steering Switch
- Steering Switch Inspection
- Steering Switch Removal/Installation
Steering
...
General Procedures (Steering)
WARNING:
Always inspect the steering component carefully for any shock or impact which
may have occurred during a collision or servicing operation. If a damaged part
or a part suspected ...
Other materials:
Pressure Control Valve Inspection [Skyactiv G 2.0]
1. Remove the pressure control valve assembly..
CAUTION:
Do not apply a pressure 36 kPa {0.37 kgf/cm2, 5.2 psi} or more. Doing so
will damage the pressure control valve and evaporative hose.
2. Apply a pressure of 36 kPa {0.37 kgf/cm2, 5.2 psi} to port A.
3. Verify that ther ...
Air Mix Actuator Removal/Installation [Full Auto Air Conditioner]
Driver-side
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Side wall (driver-side).
b. Front heat duct (LH).
3. Disconnect the air mix actuator connector.
4. Remove the screw.
5. Remove the driver-side air mix actuator.
6. Install in the reverse order ...
Tie Rod End Replacement
1. Remove the snap pin.
2. Loosen the tie-rod end locknut.
3. Detach the tie-rod end from the steering knuckle using the SST.
4. Remove the tie-rod end locknut.
5. Place alignment marks as shown in the figure for proper installation.
6. Remove the tie-rod end.
7. Align th ...
