Mazda CX-5 Service & Repair Manual: Body And Accessories SST

Abbreviations

AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC Access ...

Front Wiring Harness Protector Removal/Installation

Front Wiring Harness Protector No.1 1. Disconnect the negative battery cable.. 2. Remove the air cleaner case.. 3. While pressing the tabs of clip A in the direction of the arrows (1) shown in ...

Other materials:

Refrigerant Pressure Check
NOTE: Measure the refrigerant pressure after approx.10 min have elapsed from engine start. 1. Install the manifold gauge.. 2. Start the engine and warm it up. 3. Set the fan speed MAX HI. 4. Turn the A/C switch on. 5. Set to RECIRCULATE mode. 6. Set the temperature control ...

Rear Lateral Link Removal/Installation
1. Disconnect the rear stabilizer control link lower side nut.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the wheel alignment and adjust it if necessary.. 1 Rear lateral link outer bolt ...

Low Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The low clutch operates in 1GR, 2GR, 3GR and 4GR and intermittently operates the sun gear by drive force from the turbine shaft. For the low clutch, a centrifugal balance clutch has been adopted to prevent clutch drag and to assure stabilized piston thrust in al ...