Mazda CX-5 Service & Repair Manual: Differentials

Wheel Hub Component Removal/Installation [Awd]

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Differential Oil Inspection

1. Place the vehicle on level ground. 2. Remove the filler plug and washer. 3. Verify that the oil is at the brim of the filler plug hole. 4. If it is low, add the specified oil. 5. Instal ...

Other materials:

Knock Sensor (Ks)
Purpose/Function Detects abnormal combustion in the cylinder as basic information for mainly determining the ignition timing. Detects abnormal combustion in the combustion chamber and inputs it to the PCM as a knocking signal. Construction Installed on the cylinder ...

Blind Spot Monitoring (Bsm) Control Module Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Connect the negative battery cable.. 5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference). If the voltage is n ...

Clutch Unit Removal/Installation [C66 M R]
1. Disconnect the negative battery cable.. 2. Remove the MTX.. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 5. Add the specified amount of specified transaxle oil.. 1 Boot 2 Clutch release ...