Mazda CX-5 Service & Repair Manual: Differential Oil Temperature Sensor
Purpose, Function
-
The differential oil temperature sensor detects the rear differential oil temperature based on the resistance of the thermistor, and inputs it to the AWD CM.
Construction
-
The differential oil temperature sensor is installed in the rear differential carrier.
Operation
-
The differential oil temperature sensor uses a thermistor whose resistance changes according to changes in the rear differential oil temperature.
-
The resistance grows smaller as the oil temperature rises and vice-versa, as shown.
Fail-safe
|
DTC |
Fail-safe |
|
P1888:11 P1888:15 |
Control disabled. |
Differential Oil Replacement
1. Place the vehicle on level ground.
2. Remove the filler plug.
3. Remove the drain plug and drain the differential oil into a container.
4. Install a new washer and the drain plug, and tig ...
Differential Oil Temperature Sensor Inspection
WARNING:
Hot differential oil may cause severe burns. Do not perform maintenance while
differential oil is hot.
1. Disconnect the negative battery cable.
2. Disconnect the different ...
Other materials:
Passenger Side Air Bag Module Removal/Installation [Two Step Deployment Control
System]
WARNING:
Handling the air bag module improperly can accidentally deploy the air bag
module, which may seriously injure you. Read the air bag system service warnings
and cautions before handling the air bag module..
Due to the adoption of 2-step deployment control in the passeng ...
Cowl Grille Removal/Installation
1. Remove the windshield wiper arm and blade..
2. Pull the front fender molding in the direction of the arrow (1) while detaching
hook A.
3. Pull the front fender molding in the direction of the arrow (2) while detaching
hook B.
4. Pull the front fender molding in the direction of ...
D Pillar Speaker Inspection
D-pillar speaker
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
e. D-pillar trim.
3. Disconnect the D-pillar speaker connector..
4. Verify that the resistance between the D-pillar ...
