Mazda CX-5 Service & Repair Manual: Rear Suspension

Wheel Hub, Steering Knuckle Removal/Installation

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Befo ...

Rear Axle

Purpose, Function An angular ball bearing, with a low rotational resistance, has been adopted, improving driveability. A unit bearing that does not require pre-load setting has bee ...

Other materials:

Blind Spot Monitoring (Bsm) Control Module Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Disconnect the connector. 5. Remove the nuts. 6. Remove the BSM control module. 7. Install in the reverse order of removal. 8. Perform the BSM radar test.. CAUTION: ...

Warning Sound is Activated
Lights-On Reminder If lights are on and the ignition is switched to ACC or the ignition is switched off, a continuous beep sound will be heard when the driver's door is opened. NOTE • When the ignition is switched to ACC, the “Ignition Not Switched Off (STOP) Warning Beep”  ove ...

Cargo Compartment Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. CAUTION: Always disconnect the negative battery cable before performing the cargo compartment light bulb removal. Otherwise, the circuit may be shorted resulting in damage to the related parts such as the rear body control module (RBCM). ...