Mazda CX-5 Service & Repair Manual: Washers

Wiper And Washer Switch Removal/Installation

1. Switch the ignition ON (engine off or on). 2. Open the driver's door. 3. Switch the ignition OFF. 4. Disconnect the negative battery cable.. 5. Remove the column cover.. 6. Rotate the ...

Rear Washer Hose Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front over fender.. 3. Remove the mudguard (RH).. 4. Disconnect the rear washer hose A from the washer motor. 5. Remove the rear washer ...

Other materials:

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the trunk board.. 2. Remove the trunk end trim.. 3. Remove the rear scuff plate.. 4. Remove the trunk side trim.. 5. Disconnect the rear ABS wheel-speed sensor connector. 6. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicl ...

Front Bumper Removal/Installation
CAUTION: Affix the protective tape to the position (vehicle body side) shown in the figure to prevent scratches and damage. 1. Disconnect the negative battery cable.. 2. Remove fasteners A. 3. Pull the front over fender in the direction of the arrow shown in the figure ...

Pressure Control Valve Inspection [Skyactiv G 2.0]
1. Remove the pressure control valve assembly.. CAUTION: Do not apply a pressure 36 kPa {0.37 kgf/cm2, 5.2 psi} or more. Doing so will damage the pressure control valve and evaporative hose. 2. Apply a pressure of 36 kPa {0.37 kgf/cm2, 5.2 psi} to port A. 3. Verify that ther ...