Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Washer Fluid Level Sensor Inspection

Mazda CX-5 Service & Repair Manual / Body / Wipers, Washers / Washers / Washer Fluid Level Sensor Inspection

1. Disconnect the negative battery cable..

2. Set the front over fender aside..

3. Set the mudguard (RH) aside..

4. Remove the front bumper..

5. Inspect for continuity according to washer fluid level between the washer fluid-level sensor terminals.



Washer Fluid Level Sensor
Purpose The washer fluid-level sensor illuminates the low washer fluid level warning light when the washer fluid level is lowered. Function The washer fluid-level sensor detects ...

Washer Fluid Level Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Set the front over fender aside.. 3. Set the mudguard (RH) aside.. 4. Remove the front bumper.. 5. Disconnect the washer fluid-level sensor connec ...

Other materials:

Evaporator Temperature Sensor [Full Auto Air Conditioner]
Purpose The evaporator temperature sensor detects the airflow temperature passing through the evaporator. Function The evaporator temperature sensor converts the detected temperature to an electric signal. Construction A thermistor-type evaporator temperature s ...

Selector Lever Inspection
1. Switch the ignition ON (engine off or on). 2. Perform the following procedures to inspect the selector lever. If there is any malfunction, adjust the selector cable.. a. Verify that the selector lever can be operated as shown in the figure. b. Verify that the selector lever ...

Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. B-pillar lower trim. b. Front seat belt adjusting cover. c. Front seat belt upper anchor installation bolt. d. B-pillar upper trim. e. Trunk board. f. Trunk end trim. g. Trunk side trim. h. D-pillar trim. ...

© 2016-2026 Copyright www.mcx5.org