Mazda CX-5 Service & Repair Manual: General
- Auto Leveling Sensor
- Auto Leveling Sensor Inspection
- Auto Leveling Sensor Removal/Installation
- Auto Light Off System
- Auto Light System
- Cargo Compartment Light
- Cargo Compartment Light Bulb Removal/Installation
- Cargo Compartment Light Inspection
- Cargo Compartment Light Removal/Installation
- Lighting System Personalization
- Lighting System Personalization Features Setting Procedure
- Lighting Systems
- Parking/Front Turn Light Bulb Removal/Installation
- Rear Turn Light Bulb Removal/Installation
- Side Turn Light
- Side Turn Light Inspection
- Side Turn Light Removal/Installation
- Turn Light System
- Vanity Mirror Illumination Inspection
Lighting & Horn
...
Auto Leveling Sensor
Purpose
Detects the vehicle height and outputs it to the AFS control module.
Function
Changes the detected vehicle height into a voltage value and outputs it to
the AFS control ...
Other materials:
Flywheel Inspection [C66 M R]
1. Remove the flywheel..
2. Perform the following procedures to inspect the flywheel.
If there is any malfunction or it exceeds the maximum specification, replace
the flywheel..
a. Inspect the surface that contacts the clutch disc for scratches, nicks, and
discoloration.
...
Active Command Modes Inspection [Front Body Control Module (Fbcm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “F_BCM”.
3. Select the active command modes from the PID table.
4. Perform t ...
Rear Drive Shaft
Purpose, Function
Engine noise and vibration have been reduced due to adoption of a bell joint
on the wheel side of the constant velocity joint.
A low noise and vibration double offset joint with low slide resistance has
been adopted for the differential side of the constant v ...
