Mazda CX-5 Service & Repair Manual: Side Turn Light Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Outer mirror glass.
b. Upper outer mirror garnish.
3. Remove the screws.
4. Disconnect the connector.
5. Remove the side turn light.
6. Install in the reverse order of removal.
Side Turn Light Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Outer mirror glass.
b. Upper outer mirror garnish.
c. Side turn light.
3. Apply battery voltage to side turn ligh ...
Turn Light System
Purpose
The turn light system flashes the turn light three times automatically according
to the turn switch operation.
The front body control module (FBCM) performs turn light system ...
Other materials:
Auto Dimming Mirror
Purpose
The automatic glare prevention rearview mirror prevents the driver from being
affected by light from vehicles at the rear.
Structural view
System wiring diagram
Function
The automatic glare prevention rearview mirror detects the level of the surrounding
li ...
Start Stop Unit Removal/Installation
CAUTION:
If configuration is not performed when the start stop unit is replaced with
a new one, the vehicle specification information is not stored in the start
stop unit and the system will not operate normally.
When performing configuration, it is necessary to read the vehicl ...
Hazard Warning Flasher
The hazard warning lights should always be used when you stop on or near a roadway
in an emergency.
The hazard warning lights warn other drivers that your vehicle is a traffic hazard
and that they must take extreme caution when near it.
Depress the hazard warning flasher and all the turn sig ...
