Mazda CX-5 Service & Repair Manual: Auto Leveling Sensor
Purpose
-
Detects the vehicle height and outputs it to the AFS control module.
Function
-
Changes the detected vehicle height into a voltage value and outputs it to the AFS control module.
Construction
-
Installed to the rear cross member.
-
Consists of link No. 1, link No.2 and the Hall sensor.
Operation
1. If the rear cross member slumps under a load and passengers, the auto leveling sensor link changes.
2. The auto leveling sensor fluctuates the vehicle height value based on the link angle, and outputs the vehicle height signal to the AFS control module.
Fail-safe
-
Function not equipped.
General
...
Auto Leveling Sensor Inspection
1. Disconnect the negative battery cable..
2. Remove the auto leveling sensor..
3. Prepare three dry cell batteries (1.5 V).
4. Connect the three dry cell batteries in a series.
5. Connect ...
Other materials:
Antenna Feeder No.1 Inspection
With audio system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Decoration panel.
c. Audio unit.
3. Disconnect antenna feeder No.2.
4. Verify that the continuity between antenna feeder No.1 terminals is as indicated
in the tabl ...
Valve, Valve Spring, Valve Seal, Valve Guide
Purpose, Function
Valve
The intake valve is pressed down by the cam, the intake air passage is opened,
and air is introduced into the cylinder.
The exhaust valve is pressed down by the cam, the exhaust air passage is
opened, and combustion gas is exhausted from the cylinder.
...
Front Outer Handle Removal/Installation
1. Perform the front door glass preparation..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front door glass.
d. Front door module panel.
e. Front door key cylinder.
4. Disconnect the keyless antenna connector (With ...
