Mazda CX-5 Service & Repair Manual: Check Valve
Except U.S.A. And CANADA
Purpose, function
-
The check valve maintain the pressure in the fuel tank at constant pressure.
Construction
-
The check valve is installed to the side of the charcoal canister.
-
Mainly consists of valve, umbrella, and spring.
Operation
-
The valve moves in response to the difference in air pressure between the fuel tank side and the atmospheric side, thereby changing the path of airflow.
-
When the pressure in the fuel tank becomes negative due to fuel consumption or other factors, the path opens, drawing atmospheric air into the fuel tank.
Check Valve Removal/Installation
Except U.S.A. And CANADA
1. Remove the floor under cover..
2. Remove in the order indicated in the table.
1
Evaporative hose
2
Check valve
...
Emission System
Purpose, Outline
A single-nano catalyst has been adopted for the under-floor, three-way catalyst
to improve emission gas purification efficiency.
Structural View
Engine compartment si ...
Other materials:
Controller Area Network (Can)
Outline
The AWD control module (CM) sends and receives data to and from other modules
via the CAN system. Refer to MULTIPLEX COMMUNICATION SYSTEM for a detailed explanation
of the CAN system..
Data sent
AWD system status
Data received
Engine speed
Engin ...
Front Over Fender Removal/Installation
1. Remove fastener A.
2. Pull the front over fender lower in the direction of the arrow (1) while removing
hook B and pin C.
3. Remove fasteners D.
4. Pull the front over fender upper in the direction of the arrow (2) while removing
clips E.
5. Install in the reverse order of ...
Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax
EL]
Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input
shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the output shaft
(primary gear).
The turbine/input shaft speed sensor and output shaft speed ...
