Mazda CX-5 Service & Repair Manual: Data Network
- Active Command Modes Inspection [Front Body Control Module (Fbcm)]
- Active Command Modes Inspection [Rear Body Control Module (Rbcm)]
- Controller Area Network (Can)
- Controller Area Network (Can)
- Controller Area Network (Can) Outline
- Controller Area Network (Can) System
- Front Body Control Module (Fbcm)
- Front Body Control Module (Fbcm) Configuration (Using As Built Data)
- Front Body Control Module (Fbcm) Configuration (Using Read/Write Function)
- Front Body Control Module (Fbcm) Inspection
- Front Body Control Module (Fbcm) Removal/Installation
- Main Relay Control [Skyactiv G 2.0]
- Multiplex Communication System
- On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL, Fw6 Ax EL]
- On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]
- PID/Data Monitor Inspection [Front Body Control Module (Fbcm)]
- PID/Data Monitor Inspection [Rear Body Control Module (Rbcm)]
- Rear Body Control Module (Rbcm)
- Rear Body Control Module (Rbcm) Configuration (Using As Built Data)
- Rear Body Control Module (Rbcm) Configuration (Using Read/Write Function)
- Rear Body Control Module (Rbcm) Inspection
- Rear Body Control Module (Rbcm) Removal/Installation
Spark Plug [Skyactiv G 2.0]
Purpose, Function
The spark plug generates spark, ignition of the air-fuel mixture occurs,
and combustion of the air-fuel mixture is triggered.
Construction
The spark plug is in ...
Active Command Modes Inspection [Front Body Control Module (Fbcm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules ...
Other materials:
Front Door Glass Removal/Installation
1. Perform the front door glass preparation..
NOTE:
Before removing the front door glass, the removal procedure for the front
door glass installation bolt can be facilitated by adjusting the top of the
front door glass to the position approx. 90 mm {3.5 in} away from the
upper par ...
Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure
plate and A/C compressor pulley using a thickness gauge.
2. Verify the clearance.
If not within the specification, remove the pressure plate and adjust the
clearance by changing the shim (0.2 mm {0.008 i ...
Radiator Removal/Installation
WARNING:
Never remove the cooling system cap or loosen the radiator drain plug while
the engine is running, or when the engine and radiator are hot. Scalding engine
coolant and steam may shoot out and cause serious injury. It may also damage
the engine and cooling system.
Tu ...
