Mazda CX-5 Service & Repair Manual: On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Electrical / Data Network / On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]

1. Connect the M-MDS to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

a. Select “DataLogger”.

b. Select “Modules”.

c. Select “TCM”.

3. Select the simulation items from the PID table.

4. Perform the active command modes function, inspect the operations for each parts.

If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.

Simulation item table


Item	Description	Unit/Condition	Operation condition
SS_ON-OFF	On/off solenoid condition	Off/On	Under the following conditions: Vehicle stopped Idling at P or N position
SS1_C	Shift solenoid No.1 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SS2_C	Shift solenoid No.2 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SS3_C	Shift solenoid No.3 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SS4_C	Shift solenoid No.4 target current	A	Under the following conditions: Vehicle stopped Idling at P or N position
SSLU_C	TCC control solenoid target current	A	Under the following conditions: ATF temperature (PID: TFT) is 20 °C {68 °F} or more. Output shaft speed (PID: OSS) is 10 rpm or more. Turbine/input shaft speed (PID: TSS) is 1,000 rpm or more. Brake pedal released
SSP_C	Pressure control solenoid target current	A	Idling at P or N position

On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL, Fw6 Ax EL]

1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules� ...

PID/Data Monitor Inspection [Front Body Control Module (Fbcm)]

1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules� ...

Other materials:

Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. If the side air bag module is installed with debris i ...

R 3 5 Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The R-3-5 brake operates in 3GR, 5GR and in reverse to lock the reduction internal gear against rotation. Construction The R-3-5 brake consists of the following parts shown in the figure. The driven plate of the R-3-5 brake does not rotate be ...

Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Standard Deployment Control System]
WARNING: A live (undeployed) air bag module or pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury. Always refer to the вЂњAIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURESвЂќ and dispose of air bag modules a ...