Mazda CX-5 Service & Repair Manual: Restraints
- Restraints
- Restraints SST
- Adjuster Anchor Removal/Installation
- Air Bag Module And Pre Tensioner Seat Belt Deployment Procedures [Standard Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Deployment Procedures [Two Step Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Standard Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Two Step Deployment Control System]
- Buckle Switch Inspection
- Front Buckle Removal/Installation
- Front Seat Belt Removal/Installation
- Lap Pre Tensioner Seat Belt [Two Step Deployment Control System]
- Pre Tensioner Seat Belt [Standard Deployment Control System]
- Pre Tensioner Seat Belt [Two Step Deployment Control System]
- Rear Buckle Removal/Installation
- Rear Seat Belt Removal/Installation
- Seat Belt
- Seat Belt Inspection
Passenger Compartment Temperature Sensor [Full Auto Air Conditioner]
Purpose
The passenger compartment temperature sensor detects the cabin temperature.
Function
The passenger compartment temperature sensor converts the detected temperature
to an ...
Restraints
Abbreviations
AAS
Active Adaptive Shift
ABS
Antilock Brake System
ABDC
After Bottom Dead Center
ACC
...
Other materials:
Camshaft Position (CMP) Sensor
Purpose/Function
Detects the camshaft speed as basic information for mainly determining the
fuel injection timing and ignition timing.
Detects the camshaft speed and inputs it to the PCM as a CMP signal.
Construction
Intake CMP sensor
Installed on the cylinder head.
...
Differential [C66 M R]
Purpose, Function
The differential absorbs the rotation speed of the inside and outside wheel
of a wheel set when the vehicle is cornering.
Construction
Operation
Driving in a straight line
Cornering
...
Wheel Hub Component Removal/Installation [Awd]
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor connector (body sid ...
