Mazda CX-5 Service & Repair Manual: Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Two Step Deployment Control System]
WARNING:
-
A live (undeployed) air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury. Always refer to the “AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES” and dispose of air bag modules, pre-tensioner seat belts and lap pre-tensioner seat belts in a deployed condition.
-
The air bag modules, pre-tensioner seat belts and lap pre-tensioner seat belts are very hot immediately after they are deployed. You can be burned. Do not touch an air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt for at least 15 min after deployment.
-
Pouring water on the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt is dangerous. The water will mix with the residual gases to form a gas that can make breathing difficult. Do not pour water on the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt.
-
The deployed air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may contain deposits of sodium hydroxide, a caustic byproduct of the gas-generated combustion. If this substance gets into your eyes or on your hands, it can cause irritation and itching. When handling the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt, wear gloves and safety glasses.
1. Remove the deployed air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt.
2. Put the air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt in a plastic bag, seal the bag, and then dispose of it.
Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Standard Deployment
Control System]
WARNING:
A live (undeployed) air bag module or pre-tensioner seat belt may accidentally
operate (deploy) when it is disposed of and cause serious injury. Always refer
to the “AIR BA ...
Buckle Switch Inspection
Driver-side
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Remove the front seat..
4. Remove the front buckle..
5. Inspect for contin ...
Other materials:
Steering Features
Improved handling, fuel economy, marketability
Column assist type Electric Power Steering (EPS) adopted
Improved handling
By using a higher steering gear ratio (15.5), the steerability has
been improved
...
Rear Stabilizer Removal/Installation [2 Wd]
WARNING:
Verify that the rear crossmember is securely supported by a jack. If the
rear crossmember falls off, it can cause serious injury or death, and damage
to the vehicle.
CAUTION:
Performing the following procedures without first removing the rear ABS wheel-spee ...
Blind Spot Monitoring (Bsm) Bracket Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear combination lights.
b. Rear bumper.
c. BSM control module.
3. Remove the nuts.
4. While pressing the clip tabs in the direction of the arrows (1) shown in the
figure, press the clip in the direction o ...
