Mazda CX-5 Service & Repair Manual: Restraints SST

Restraints

Abbreviations AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC ...

Adjuster Anchor Removal/Installation

WARNING: The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery cable or work carefully, avoiding excess ...

Other materials:

Blind Spot Monitoring (Bsm) Control Module Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Connect the negative battery cable.. 5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference). If the voltage is n ...

Power Window Main Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the cover A. 3. Insert a tape-wrapped fastener remover shown in the figure and remove the tab B in the direction of arrow (1). 4. Slide the power window main switch cover in the direction of the arrow (2) shown in the figure and ...

Starter Cut Off Control [Skyactiv G 2.0]
Outline The PCM controls energization to the starter relay according to an immobilizer system request to improve security. While not in P or N position, the starter relay energization by the ignition key is inhibited. (ATX) While not in neutral, the starter relay energiz ...