Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Seat Belt

Outline (Standard Deployment Control System)

Outline (Two-step Deployment Control System)

Structural View


Purpose

Function

Standard deployment control system

Seat belt

Type

Function

Front seat belt (Driver-side, passenger-side)

Three-point

  • Load limiter

  • ELR (Emergency Locking Retractor)

  • Pre-tensioner seat belt

Rear seat belt (RH, LH)

Three-point

  • ELR (Emergency Locking Retractor)

  • ALR (Automatic Locking Retractor)

Rear center seat belt

Three-point

  • ELR (Emergency Locking Retractor)

  • ALR (Automatic Locking Retractor)


Two-step deployment control system

Seat belt

Type

Function

Front seat belt (Driver-side)

Three-point

  • Load limiter

  • ELR (Emergency Locking Retractor)

  • Pre-tensioner seat belt

  • Lap pre-tensioner seat belt

Front seat belt (Passenger-side)

Three-point

  • Load limiter

  • ELR (Emergency Locking Retractor)

  • ALR (Automatic Locking Retractor)

  • Pre-tensioner seat belt

  • Lap pre-tensioner seat belt

Rear seat belt (RH, LH)

Three-point

  • ELR (Emergency Locking Retractor)

  • ALR (Automatic Locking Retractor)

Rear center seat belt

Three-point

  • ELR (Emergency Locking Retractor)

  • ALR (Automatic Locking Retractor)


Load limiter

ELR (Emergency Locking Retractor)

ALR (Automatic Locking Retractor)

Pre-tensioner seat belt

Lap pre-tensioner seat belt

Construction


Fail-safe

Rear Seat Belt Removal/Installation
CAUTION: The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not wor ...

Seat Belt Inspection
Belt 1. Verify that the belt is installed properly with no twists or kinks. 2. Verify that there is no damage to the seat belt and no deformation of the metal fittings. If there is any ma ...

Other materials:

Fuel Tank Pressure Sensor Inspection
Voltage Inspection NOTE: The fuel tank pressure sensor cannot be removed as a single unit. When replacing the fuel tank pressure sensor, replace it together with the charcoal canister as a single unit. 1. Disconnect the negative battery cable.. 2. Disconnect the fuel tank pres ...

Rear Turn Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover, and detach the serv ...

No.27 Fuel Refill Concerns
27 FUEL REFILL CONCERNS DESCRIPTION Fuel tank does not fill smoothly. POSSIBLE CAUSE PCM DTC is stored. Non-return valve malfunction Pressure control v ...

© 2016-2025 Copyright www.mcx5.org