Mazda CX-5 Service & Repair Manual: Mirrors

Vanity Mirror Illumination Bulb Removal/Installation

1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move a flathead screwdriver in the dire ...

Auto Dimming Mirror

Purpose The automatic glare prevention rearview mirror prevents the driver from being affected by light from vehicles at the rear. Structural view System wiring diagram Funct ...

Other materials:

Washer Motor Removal/Installation
1. Disconnect the negative battery cable.. 2. Set the front over fender aside.. 3. Set the mudguard (RH) aside.. 4. Remove the front bumper.. 5. Disconnect the washer motor connector from the washer motor. 6. Disconnect the windshield washer hose from the washer motor. 7. Disconnect the ...

Rear Upper Arm Removal/Installation [Awd]
WARNING: Verify that the crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-speed sensor ...

Floor Covering Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate. b. Front side trim. c. Rear scuff plate. d. B-pillar lower trim. e. Rear seat cushion. f. Front seat. g. Lower anchor of the front seat belt (without lap pre-tensioner seat belt). h. La ...