Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Mirror Base Installation

Mazda CX-5 Service & Repair Manual / Body / Mirrors / Mirror Base Installation

1. Cut away all of the original sealant using a razor.

WARNING:

2. Clean and degrease the ceramic coating on the glass and the base.

CAUTION:

3. Apply primer to the bonding area of the glass and the base.

4. Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approx. 30 min.

5. Apply 3.0 mm {0.12 in}

layer of sealant to the base.


6. Center the base in the ceramic coating and press it onto the glass.


7. Use isopropyl alcohol to remove any excess repair sealant. Hardening time of sealant


Temperature

Surface hardening time

Time required until car can be put into service

5 °C {41 °F}

Approx. 1.5 h

Approx. 12 h

20 °C {68 °F}

Approx. 1 h

Approx. 4 h

35 °C {95 °F}

Approx. 10 min

Approx. 2 h


8. Install the rearview mirror. (without auto-dimming mirror).

9. Install the auto-dimming mirror. (with auto-dimming mirror).

Glass/Windows/Mirrors
Outline The following glass has been adopted. Windshield Front door glass Rear door glass Rear door quarter glass Quarter window glass ...

Mirror Base Removal
1. Disconnect the negative battery cable.. 2. Remove the rearview mirror. (without auto-dimming mirror). 3. Remove the auto-dimming mirror. (with auto-dimming mirror). 4. Wind each end of a wire ...

Other materials:

Fuel Draining Procedure
WARNING: Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. To prevent this, complete the following inspection with the engine stopped. Fuel is very flammable liquid. If fuel spills or leaks ...

Panel Light Control Indicator Alarm
Purpose The panel light control indicator alarm notifies the driver that the panel light brightness is either at maximum or minimum. Function If the panel light control switch is in the maximum rotation position right or left when the TNS switch ON signal (TNS and headlight ...

Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Description BSM indicator light flashes while not under BSM indicator light-flashing conditions (no combination switch operation (turn signal switch) The BSM indicator light flashes despite not satisfying the BSM indicator light flashing ...

© 2016-2026 Copyright www.mcx5.org