Mazda CX-5 Service & Repair Manual: Glass/Windows/Mirrors
Outline
-
The following glass has been adopted.
-
Windshield
-
Front door glass
-
Rear door glass
-
Rear door quarter glass
-
Quarter window glass
-
Rear window glass
-
Outer mirror glass
-
The following mirrors have been adopted.
-
Power outer mirror
-
Rearview mirror
-
Auto-dimming mirror (with auto-dimming mirror)
-
Rear window defroster has been adopted on the rear window glass.
-
Heated outer mirror has been adopted on the power outer mirrors. (with heated outer mirror system)
-
An auto-dimming mirror has been adopted on the rearview mirror. (with auto-dimming mirror)
-
UV protection glass has been adopted. (with UV protection glass)
Specification
-
Glass is thinner than for weight reduction.
-
Windshield: 4.5 mm
{0.18 in
}
-
Front door glass: 4.0 mm
{0.16 in
}
-
Rear door glass: 3.5 mm
{0.14 in
}
-
Rear door quarter glass: 3.1 mm
{0.12 in
}
-
Quarter window glass: 2.8 mm
{0.11 in
}
-
Rear window glass: 2.8 mm
{0.11 in
}
Structural view
Filament Repair
1. Clean the filament using isopropyl alcohol.
2. Attach tape to both sides of the filament.
3. Using a small brush or marking pen, apply silver paint.
4. After 2—3 min, carefully remove t ...
Mirror Base Installation
1. Cut away all of the original sealant using a razor.
WARNING:
Using a razor with bare hands can cause injury. Always wear gloves when using
a razor.
2. Clean and degrease the cera ...
Other materials:
Room Light Control System
Outline
The room light control system changes the illumination condition and illumination
level of the interior lights (door position) according to whether the doors
are opened/closed and locked/unlocked.
The room light control system is controlled by the rear body control modul ...
Engine Coolant Temperature (ECT) Sensor
Purpose/Function
Detects the ECT as basic information for mainly determining the fuel injection
amount.
Detects the ECT and inputs it to the PCM as an ECT signal.
The ECT sensor No.2 is only used for OBD.
Construction
ECT sensor No.1
Installed to the water out ...
Engine Coolant Temperature (ECT) Sensor Inspection
Resistance Inspection
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Remove the ECT sensor No.1..
2. Place the ECT sensor No.1 in water with a thermometer, and heat the water
...
