Mazda CX-5 Service & Repair Manual: Auto Dimming Mirror Inspection
1. Measure the voltage at each terminal.
-
If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring harnesses.
-
If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the auto-dimming mirror.
Terminal Voltage Table (Reference)
|
Terminal |
Signal name |
Connected to |
Measured condition |
Voltage (V) |
Inspection item(s) |
|
A |
— |
— |
— |
— |
— |
|
B |
IG1 |
C/U IG1 15A fuse |
Switch the ignition ON (engine on or off) |
B+ |
|
|
Switch the ignition OFF (LOCK) |
1.0 or less |
||||
|
C |
— |
— |
— |
— |
— |
|
D |
R position signal |
Rear body control module (RBCM) |
R position |
B+ |
|
|
Other than R position |
1.0 or less |
||||
|
E |
— |
— |
— |
— |
— |
|
F |
GND |
Body ground |
Under any condition |
1.0 or less |
|
|
G |
— |
— |
— |
— |
— |
|
H |
— |
— |
— |
— |
— |
|
I |
— |
— |
— |
— |
— |
|
J |
Power supply |
ROOM 15 A fuse |
Under any condition |
B+ |
|
Auto Dimming Mirror
Purpose
The automatic glare prevention rearview mirror prevents the driver from being
affected by light from vehicles at the rear.
Structural view
System wiring diagram
Funct ...
Auto Dimming Mirror Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the screw B.
3. Remove the auto-dimming mirror in the direction of arrow (1) shown in the
figure.
4. Detach tabs while push the cov ...
Other materials:
Sunvisor Removal/Installation
1. Disconnect the negative battery cable. (with vanity mirror illumination).
2. Remove the screw A.
3. Rotate the sunvisor in the direction of the arrow.
4. Unhook and remove the sunvisor.
5. Disconnect the vanity mirror illumination connector. (with vanity mirror illumination)
6. Pr ...
Evaporator Temperature Sensor [Manual Air Conditioner]
Purpose
The evaporator temperature sensor detects the airflow temperature passing
through the evaporator.
Function
The evaporator temperature sensor converts the detected temperature to an
electric signal.
Construction
A thermistor-type evaporator temperature s ...
Rear Body Control Module (Rbcm) Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
