Mazda CX-5 Service & Repair Manual: General
- Air Filter
- Air Filter Inspection
- Air Filter Removal/Installation
- Air Fuel Ratio (A/F) Sensor Heater Control [Skyactiv G 2.0]
- Airflow Mode Main Link Removal/Installation
- Basic System
- Blower Unit
- Blower Unit Disassembly/Assembly
- Blower Unit Removal/Installation
- Front Heat Duct Removal/Installation
- Heated Oxygen Sensor (HO2 S) Heater Control [Skyactiv G 2.0]
- Heater Core
- Heater Core Inspection
- Heater Hose Removal/Installation
- Rear Heat Duct Removal/Installation
- Rear Window Defroster/Outer Mirror Heater
HVAC
...
Air Filter
Purpose
The air filter removes pollen and dust in the intake air and purifies air
flowing into the cabin.
Function
The air filter removes pollen and dust using a dust collecting ...
Other materials:
Liftgate Opener Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
d. Liftgate garnish.
e. Liftgate opener switch.
3. Verify the continuity of liftgate opener switch terminals B and C.
If not as i ...
Filament Repair
1. Clean the filament using isopropyl alcohol.
2. Attach tape to both sides of the filament.
3. Using a small brush or marking pen, apply silver paint.
4. After 2—3 min, carefully remove the tape without damaging the applied
area.
CAUTION:
Do not operate the rear window defro ...
Washer Fluid Level Sensor Removal/Installation
1. Disconnect the negative battery cable..
2. Set the front over fender aside..
3. Set the mudguard (RH) aside..
4. Remove the front bumper..
5. Disconnect the washer fluid-level sensor connector.
6. Remove the washer fluid-level sensor.
NOTE:
If the washer fluid-level sensor ...
