Mazda CX-5 Service & Repair Manual: Blower Unit Disassembly/Assembly
CAUTION:
-
Apply only the specified grease to the link. Otherwise abnormal noise or improper operation may result.
1. Disassemble in the order indicated in the table.
|
1 |
Air filter |
|
2 |
Harness |
|
3 |
Blower motor |
|
4 |
Cover |
|
5 |
Air intake actuator |
|
6 |
Air intake link |
|
7 |
Polyurethane (1) |
|
8 |
Polyurethane (2) |
|
9 |
Polyurethane (3) |
|
10 |
Blower case (1) |
|
11 |
Blower case (2) |
|
12 |
Air intake door |
2. Assemble in the reverse order of disassembly.
Blower Unit
Purpose
The blower unit switches between fresh air and recirculated air (FRESH/REC)
and sends airflow into the cabin.
Function
Air is blown by the blower motor in the blower uni ...
Blower Unit Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (passenger-side).
b. Front side trim (passenger-side).
c. Dashboard under cover.
d. Glove compa ...
Other materials:
Front Seat Cushion Frame Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both side ...
Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Trunk board.
c. Trunk end trim (RH).
d. Rear scuff plate (RH).
e. Trunk side trim (RH).
3. Disconnect antenna feeder No.1.
4. Disconnect antenna feeder No.3.
5. Verify that t ...
Seat Weight Sensor Control Module Removal/Installation [Two Step Deployment
Control System]
CAUTION:
When the seat weight sensor control module is replaced with a new one, perform
the seat weight sensor calibration using the M?MDS..
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Disconnect the connectors.
...
