Mazda CX-5 Service & Repair Manual: Starting, Charging

Rear Body Control Module (Rbcm) Removal/Installation

CAUTION: If configuration is not performed when the rear body control module (RBCM) is replaced with a new one, the vehicle specification information is not stored in the rear body contr ...

Charging System Warning Light [Skyactiv G 2.0]

Purpose, Function Warns the driver of a charging system malfunction. Construction The charging system warning light is built into the instrument cluster.. Operation ...

Other materials:

Car Navigation System Does Not Start Operation [Car Navigation System]
Possible DTC Even if the NAVI mode is selected, the car-navigation system screen does not display. POSSIBLE CAUSE NAV switch malfunction Power supply fuse (+B, ACC) burnt out Open or short circui ...

D Pillar Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. 3. Take the shaded area shown in the figure, and remove the D-pillar trim in the direction of the arrow in the order of (1), (2), (3) wh ...

Fuel Pump Control Module Inspection
1. Perform the KOEO self-test.. 2. Verify that a fuel pump control module related DTC is detected.. If DTCs are detected, repair the malfunctioning part according to the applicable DTC troubleshooting.. If a DTC is not detected, go to the next step. 3. Inspect the followin ...