Mazda CX-5 Service & Repair Manual: Data Network
- Active Command Modes Inspection [Front Body Control Module (Fbcm)]
- Active Command Modes Inspection [Rear Body Control Module (Rbcm)]
- Controller Area Network (Can)
- Controller Area Network (Can)
- Controller Area Network (Can) Outline
- Controller Area Network (Can) System
- Front Body Control Module (Fbcm)
- Front Body Control Module (Fbcm) Configuration (Using As Built Data)
- Front Body Control Module (Fbcm) Configuration (Using Read/Write Function)
- Front Body Control Module (Fbcm) Inspection
- Front Body Control Module (Fbcm) Removal/Installation
- Main Relay Control [Skyactiv G 2.0]
- Multiplex Communication System
- On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL, Fw6 Ax EL]
- On Board Diagnostic System Simulation Inspection [Fw6 A EL, Fw6 Ax EL]
- PID/Data Monitor Inspection [Front Body Control Module (Fbcm)]
- PID/Data Monitor Inspection [Rear Body Control Module (Rbcm)]
- Rear Body Control Module (Rbcm)
- Rear Body Control Module (Rbcm) Configuration (Using As Built Data)
- Rear Body Control Module (Rbcm) Configuration (Using Read/Write Function)
- Rear Body Control Module (Rbcm) Inspection
- Rear Body Control Module (Rbcm) Removal/Installation
Spark Plug [Skyactiv G 2.0]
Purpose, Function
The spark plug generates spark, ignition of the air-fuel mixture occurs,
and combustion of the air-fuel mixture is triggered.
Construction
The spark plug is in ...
Active Command Modes Inspection [Front Body Control Module (Fbcm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules ...
Other materials:
Dashboard Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
c. Windshield wiper motor.
d. Front scuff plate.
e. Front side trim.
f. Glove compartment.
g. Dashboard under cover.
h. Decoration panel.
i. Center panel. ...
Intake Air Temperature (Iat) Sensor Inspection
IAT Sensor No.1
Resistance inspection
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1.
1. Disconnect the negative battery cable..
2. Disconnect the MAF sensor/IAT sensor No.1 ...
Headlight Aiming
NOTE:
Perform headlight aiming if any of the following work is performed.
Front combination light replacement
Work that can affect vehicle height such as suspension replacement or
removal/installation.
1. Empty the vehicle by having all occupants leav ...
