Mazda CX-5 Service & Repair Manual: Amenities

Upper Panel Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front console box. b. Shift lever knob (MTX). c. Shift panel. 3. Open the console lid. 4. Remove the button, th ...

Assist Handle Removal/Installation

Removal 1. Insert a tape-wrapped flathead screwdriver into the service hole and remove the assist handle covers. 2. Remove the assist handle in the direction of the arrow (1) and (2), while ...

Other materials:

Precaution [Dynamic Stability Control (DSC)]
1. The ABS warning light and/or brake system warning light and/or TCS/DSC indicator light and/or TCS OFF indicator light illuminate even when the system is normal. Warning lights/Indicator lights that may illuminate and/or flash Cases in which the light may ill ...

Wheel Hub, Steering Knuckle Inspection
Wheel Bearing Excessive Play Inspection 1. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play. If it exceeds the maximum specification, replace the wheel hub bearing. Front wheel bearing maximum play 0 ...

Front Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...