Mazda CX-5 Service & Repair Manual: Wipers

Washer Fluid Level Sensor Removal/Installation

1. Disconnect the negative battery cable.. 2. Set the front over fender aside.. 3. Set the mudguard (RH) aside.. 4. Remove the front bumper.. 5. Disconnect the washer fluid-level sensor connec ...

Auto Wiper System

Outline The auto wiper system detects the amount of rainfall on the windshield and automatically operates the windshield wipers intermittently or at low/high speed and stops. Using the se ...

Other materials:

Wheel Hub Component Removal/Installation [2 Wd]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (body sid ...

Purge Control
Outline An appropriate amount of evaporative gas is fed into the intake manifold by the purge solenoid valve operation according to the engine operation conditions. This ensures driveability and prevents release of evaporative gas into the atmosphere. The PCM drives the purge so ...

Front Door Speaker Removal/Installation
Without Bose® NOTE: If the procedure is performed while holding the front door speaker cone, it could deform the cone causing a malfunction. Therefore, perform the procedure while holding any part other than the cone. 1. Disconnect the negative battery cable.. 2. Remove the f ...