Mazda CX-5 Service & Repair Manual: Wheels, Tires
- Wheel Alignment Pre Inspection
- Wheel Apron Component Installation [Panel Replacement]
- Wheel Apron Component Removal [Panel Replacement]
- Wheel Balance Adjustment (Aluminum Alloy Wheel)
- Wheels And Tires
- Tire Pressure Monitoring System (TPMS)
- Tire Pressure Monitoring System Initialization Procedure
- Tire Pressure Monitoring System Set Switch
- Tire Pressure Monitoring System Set Switch Inspection
- Tire Pressure Monitoring System Set Switch Removal/Installation
- Tire Pressure Monitoring System Warning Light
- Tire Pressure Warning Alarm
Rear Upper Arm Removal/Installation [Awd]
WARNING:
Verify that the crossmember is securely supported by a jack. If the rear
crossmember falls off, it can cause serious injury or death, and damage to the
vehicle.
CAUTIO ...
Wheel Alignment Pre Inspection
1. Park the vehicle on level ground, in an unloaded condition*, with the wheels
straight forward.
*: Unloaded condition.....Fuel tank is full. Engine coolant and engine oil are
at specified leve ...
Other materials:
Steering Wheel And Column Inspection
Play inspection
1. With the wheels in the straight-ahead position, start the engine.
2. Turn the steering wheel to the left and right gently, then verify that the
steering wheel play is within the specification.
Steering wheel play
0—30 mm {0—1.1 in}
Looseness, Exces ...
Awd Solenoid Inspection
1. Disconnect the negative battery cable.
2. Disconnect the AWD solenoid connector.
3. Measure resistance between AWD solenoid connector terminals A and B.
If the resistance is not within the specification, replace the coupling unit.
AWD solenoid resistance
2.2—2.7 oh ...
Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The down switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the selector lever component connector.
4. Verify that the continuity between selector lever compone ...
