Purpose, Function
The tire pressure monitoring system warning light notifies the driver that it was determined that a tire pressure has decreased below the specified value based on the initialization.
The tire pressure monitoring system warning light notifies the driver that a malfunction has occurred in the tire pressure monitoring system.
Construction, Operation
The tire pressure monitoring system warning light is built into the instrument cluster.

The tire pressure monitoring system warning light illuminates/flashes based on the DSC HU/CM command.
The tire pressure monitoring system warning light illuminates if a tire pressure decreases below the specified value based on the initialization.
The tire pressure monitoring system warning light flashes for 1 min if a malfunction is detected in the tire pressure monitoring system, and then it illuminates.
If the tire pressure monitoring system warning light has illuminated, it will turn off by performing the initialization. If the initialization is not performed, the light will illuminate again when the ignition is switched from off to ON.
Fail-safe
Function not equipped.
Tire Pressure Monitoring System Set Switch Removal/Installation
Tire Pressure Warning AlarmStarter Interlock Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the starter interlock switch connector.
3. Remove the starter interlock using the following procedure:
a. Detach hook A in the direction of the arrow shown in the figure.
b. Slide the starter interlock switch in the direction of th ...
Presilencer
Purpose, Function
Reduces the exhaust noise.
Construction
The presilencer is installed to the rear of the TWC.
2WD
AWD
The presilencer consists of the filters, stuffing and wool-stainless.
2WD
AWD
...
Resistor Removal/Installation [Manual Air Conditioner]
NOTE:
When removing the resistor, perform the procedure in the posture shown in
the figure.
1. Disconnect the negative battery cable..
2. Remove the dashboard under cover..
3. Disconnect the connector.
4. Rotate the resistor (2) while pressing the tab (1).
5. R ...