Mazda CX-5 Service & Repair Manual: Tire Pressure Monitoring System Set Switch
Purpose
-
The tire pressure monitoring system set switch is used to initialize the tire pressure monitoring system.
Construction, Operation
-
The tire pressure monitoring system set switch is installed to the instrument panel.
-
The tire pressure monitoring system set switch has adopted a monitoring type switch.
-
The tire pressure monitoring system set switch sends a tire pressure monitoring system initialization signal to the instrument cluster.
Fail-safe
|
DTC |
Fail-safe |
|
C1031:35 |
Inhibits the TPMS control. |
Tire Pressure Monitoring System Initialization Procedure
Perform the tire pressure monitoring system initialization when the following
operations have been performed:
Tire pressures have been adjusted
Tires or wheels have ...
Tire Pressure Monitoring System Set Switch Inspection
1. Remove the TPMS set switch..
2. Verify that the resistance between the TPMS set switch terminals B and C is
as indicated in the table.
If not as indicated in the table, replace the TP ...
Other materials:
Column Cover Removal/Installation
1. Pull down the steering wheel.
2. Press the shaded area shown in the figure using your thumb, and lift the upper
column cover in the direction of arrow (1).
3. Pull the upper column cover in the direction of the arrow (2) and remove it
while detaching pins A, tabs B and guides C.
4. ...
Liftgate Light
Purpose
The liftgate lights are used to signal the following conditions to vehicles/people
at the rear.
Back-up lights: Signals that the vehicle is backing up.
Taillights: Signals the presence of the vehicle during nighttime.
Function
The back-up ...
Starter Interlock Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the starter interlock switch connector.
3. Remove the starter interlock using the following procedure:
a. Detach hook A in the direction of the arrow shown in the figure.
b. Slide the starter interlock switch in the direction of th ...
