Mazda CX-5 Service & Repair Manual: Vehicle General
- How To Use This Manual
- Abbreviations
- Body And Accessories SST
- Front Wiring Harness Protector Removal/Installation
- Identification Number Locations
- Jacking Positions, Vehicle Lift (2 Supports) And Safety Stand (Rigid Rack) Positions
- Personalization Features
- Pre Delivery Inspection
- Push Button Start Inspection
- Push Button Start Removal/Installation
- Sae Standards
- Service Cautions
- St 001/12 Special Service Tool Shipment January 2013
- Units
- Vehicle Identification Number (VIN) Code
How To Use This Manual
Range of Topics
This manual contains procedures for performing all required service operations.
The procedures are divided into the following five basic operations:
Removal/Inst ...
Other materials:
Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The down switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the selector lever component connector.
4. Verify that the continuity between selector lever compone ...
Cowl Upper Plate Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
A/C Unit Removal/Installation
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Drain the engine coolant..
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability
will be lowered and abnormal noise or other malfunction could occur. Always
plug open f ...
