Mazda CX-5 Service & Repair Manual: St 001/12 Special Service Tool Shipment January 2013
APPLICABLE MODEL(S)/VINS
2014 Mazda6
2014 CX-5
DESCRIPTION/PRICING
In support of the new 2014 Mazda6 and the 2014 CX-5, Mazda will ship to all dealers one (1) new Special Service Tool (SST). The SST will be shipped automatically by Mazda’s tool vendor, SPX during January 2013.
The following SST is the latest addition to the Mazda Required Tool (MRT) list.
|
Part Number |
Description |
Pricing |
|
MAZ009922 |
Laser Sensor Targeting Plate |
$19.83 |
BILLING INFORMATION
Tool(s) will be automatically invoiced to your dealer parts account statement. If your accounting department has any questions regarding this invoicing, please call Mazda Special Service Tools (949-442-6539).
SHIPPING INFORMATION
Tools will be shipped via UPS Ground to your service department January 2013. Please advise your shipping/receiving personnel of this tool shipment.
OBTAINING ADDITIONAL TOOLS
To order additional SSTs, submit orders via MStore at http://dealers.mazdausa.com.
CUSTOMER SERVICE INFORMATION
For warranty or product information call SPX Special Service Tools at (800)533-5338.
SPECIAL SERVICE TOOL (SST) AND USAGE
|
PART NUMBER / NAME : MAZ009922 Laser Sensor Targeting Plate APPLICABLE MODELS : 2014 Mazda6 2013 CX-5 USAGE : To check for proper operation of the laser sensor on vehicles equipped with Smart City Braking (SCBS). |
OVERVIEW |
USAGE See the Dynamic Stabilty Control (DSC) section 04-15 of the Workshop Manual for more information. |
Service Cautions
Injury/damage Prevention Precautions
Depending on the vehicle, the cooling fan may operate suddenly even when
the ignition is switched to off. Therefore, keep hands and tools away from the
...
Units
Electric current
A (ampere)
Electric power
W (watt)
Electric resistance
ohm
Electric voltage
...
Other materials:
Front Heat Duct Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Dashboard under cover.
b. Side wall.
c. Glove compartment.
3. Detach the tab and remove the front heat duct.
LH
RH
4. Install in the reverse order of removal. ...
Front Door Trim Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Insert a tape-wrapped flathead screwdriver in the position indicated by the
arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin
B.
4. Remove the screw C.
5. Remove the cover ...
Reduction Gear
Purpose/ Function
The reduction gear transmits the rotation input from the EPS motor, decreasing
the rotation speed and increasing the torque simultaneously.
Construction
The reduction gear consists of the worm wheel located on the steering column
main shaft and the worm sh ...
