Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Identification Number Locations

Mazda CX-5 Service & Repair Manual / Vehicle General / Identification Number Locations

Vehicle Identification Number (VIN)

Engine Type/Number

SKYACTIV-G 2.0


SKYACTIV-G 2.5


Front Wiring Harness Protector Removal/Installation
Front Wiring Harness Protector No.1 1. Disconnect the negative battery cable.. 2. Remove the air cleaner case.. 3. While pressing the tabs of clip A in the direction of the arrows (1) shown in ...

Jacking Positions, Vehicle Lift (2 Supports) And Safety Stand (Rigid Rack) Positions
Jacking Positions WARNING: Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking points and ...

Other materials:

Wiper/Washer System Personalization
A customize function has been adopted which switches the auto wiper system between operable/inoperable. Using Mazda Modular Diagnostic System (M-MDS) The auto wiper function can be enabled or disabled using the Mazda Modular Diagnostic System (M-MDS). Refer to the Workshop M ...

Door Lock Switch Inspection
Driver's Side 1. Disconnect the negative battery cable.. 2. Remove the door lock switch.. 3. Verify that the continuity is as indicated in the table. If the continuity is not as indicated in the table, replace the door lock switch. Passenger's Side 1. Disconnec ...

Rear Pillar (Outer) Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

© 2016-2026 Copyright www.mcx5.org