Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Rear ABS Wheel Speed Sensor Removal/Installation

1. Remove the trunk board.. 2. Remove the trunk end trim.. 3. Remove the rear scuff plate.. 4. Remove the trunk side trim.. 5. Disconnect the rear ABS wheel-speed sensor connector. 6. Pr ...

ABS Wheel Speed Sensor And ABS Sensor Rotor

Purpose/Function The ABS wheel-speed sensor and ABS sensor rotor detect the rotation condition of each wheel and transmit this information to the DSC HU/CM. The signal from the ABS w ...

Other materials:

Front Body Control Module (Fbcm) Removal/Installation
CAUTION: If configuration is not performed when the front body control module (FBCM) is replaced with a new one, the vehicle specification information is not stored in the front body control module (FBCM) and the system will not operate normally. When performing configuration, ...

Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection CAUTION: Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor. 1. Switch the ignition to off. 2. Connect the M-MDS to the DLC-2. ...

Condenser Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim (LH). c. Rear scuff plate (LH). d. Trunk side trim (LH). e. D-pillar trim (LH). 3. Disconnect the connector. 4. Remove the bolts. 5. Remove the condenser. 6. Install in ...