Mazda CX-5 Service & Repair Manual: Power Sockets

Global Positioning System (Gps) Antenna Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the center speaker grille.. 3. Disconnect the connector. 4. Remove the screw. 5. Remove the GPS antenna. 6. Install in the reverse or ...

Accessory Socket

Purpose By inserting the plug of an electrical device, 12 V (maximum 120 W) of power is supplied enabling use of the electrical device in the vehicle. Function Front accessory socket ...

Other materials:

Rear Seat Back Frame Removal/Installation
CAUTION: When performing the procedure with a rear seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat. 6:4 Split Type 1. Remove the trunk board.. 2. Remove the rear seat back.. 3. Remove the headrest. 4. Open fasteners A ...

Panel Light Control Indicator Alarm
Purpose The panel light control indicator alarm notifies the driver that the panel light brightness is either at maximum or minimum. Function If the panel light control switch is in the maximum rotation position right or left when the TNS switch ON signal (TNS and headlight ...

Front Body Control Module (Fbcm) Configuration (Using Read/Write Function)
NOTE: When performing configuration, it is necessary to read the vehicle specification information from the front body control module (FBCM) before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the front body control module (FBCM). ...