Door Lock Switch Removal/Installation
Keyless Antenna Removal/InstallationHeated Oxygen Sensor (HO2 S) Inspection
HO2S Inspection
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine on).
3. Warm up the engine to normal operating temperature.
4. Access the following PIDs using the M-MDS..
VSS (Vehicle speed)
RPM (Engine speed)
O2S12 (HO2S output voltage)
5. D ...
How to Use This Manual
We want to help you get the most driving pleasure from your vehicle. Your owner's
manual, when read from cover to cover, can do that in many ways.
Illustrations complement the words of the manual to best explain how to enjoy
your Mazda. By reading your manual, you can find out about the fea ...
Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. B-pillar lower trim.
b. Front seat belt adjusting cover.
c. Front seat belt upper anchor installation bolt.
d. B-pillar upper trim.
e. Trunk board.
f. Trunk end trim.
g. Trunk side trim.
h. D-pillar trim. ...