Purpose
Outputs a request signal and specifies the remote transmitter location.
Function
The keyless antennas output request signals based on the signals from the start stop unit.
Construction, Operation
Request signals are output by the keyless antenna installed in the rear console to produce the keyless antenna output range inside the vehicle.

Fail-safe
Function not equipped.
Keyless Antenna [Advanced Keyless Entry System]
Keyless BeeperEssential Information
Introduction
Be extremely careful and prevent injury to yourself and others or damage to your
vehicle when using this manual for inspection and maintenance.
If you are unsure about any procedure it describes, we strongly urge you to have
a reliable and qualified service shop perform the work ...
Ventilator Grille Removal/Installation
Side Ventilator Grille
Driver-side
1. Disconnect the negative battery cable..
2. Remove the switch panel..
3. Insert your hand from the area where the switch panel was installed, remove
the side ventilator grille in the direction of the arrow shown in the figure while
detaching hooks A.
...
Shift Solenoid No.2 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
Shift solenoid No.2 adjusts the hydraulic pressure in the 2-6 brake circuit
based on the current demand from the TCM according to the vehicle conditions.
Construction
Shift solenoid No.2 is installed to the solenoid control valve body.
Shift solenoid N ...