Mazda CX-5 Service & Repair Manual: Security & Keyless Entry

PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]

1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules� ...

Remote Transmitter Battery Voltage Inspection

NOTE: Because the remote transmitter battery power cannot be determined using the battery itself, determine by the remote transmitter battery low warning operation conditions. Oper ...

Other materials:

Front Combination Light Disassembly/Assembly
1. Disassemble in the order shown in the figure. Halogen type 1 Short cord (See Short Cord Removal Note.) 2 Parking/Front turn light bulb (See PARKING/FRONT TURN LIGHT BULB REMOVAL/INSTALLATION.) 3 Headlight ...

Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. B-pillar lower trim. b. Front seat belt adjusting cover. c. Front seat belt upper anchor installation bolt. d. B-pillar upper trim. e. Trunk board. f. Trunk end trim. g. Trunk side trim. h. D-pillar trim. ...

Wheel Hub, Steering Knuckle Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle sid ...