Mazda CX-5 Service & Repair Manual: Disc Brakes

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]

Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the ...

Caliper (Front) Disassembly/Assembly

1. Disassemble in the order indicated in the table. 1 Bleeder cap 2 Bleeder screw 3 Piston (See Piston Disassem ...

Other materials:

Resistor Removal/Installation [Manual Air Conditioner]
NOTE: When removing the resistor, perform the procedure in the posture shown in the figure. 1. Disconnect the negative battery cable.. 2. Remove the dashboard under cover.. 3. Disconnect the connector. 4. Rotate the resistor (2) while pressing the tab (1). 5. R ...

Procedure [Plastic Body Parts]
Repair of polypropylene bumpers having damage that has reached the surface of the polypropylene and are too serious to be restored by painting only. 1. Cut the rough edges around the damage with a knife to make it smooth. Sand the area with a sander to make an angle of about 45°. 2. ...

Front Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Seal board upper. b. Front bumper. c. Front combination light. d. Set plate. e. Energy-absorbing form. f. Front under cover No.1. g. Bumper stiffener lower. 3. Support the shroud panel using a jack. CAUT ...