Mazda CX-5 Service & Repair Manual: Engine Assembly

Refrigerant Pressure Sensor [Manual Air Conditioner]

Purpose The refrigerant pressure sensor detects the refrigerant pressure in the refrigerant cycle. Function The refrigerant pressure sensor converts the detected refrigerant pre ...

Cylinder Block

Purpose, Function The cylinder block forms the cylinder and crankcase. Construction The cylinder block consists of the upper cylinder block and lower cylinder block. The ...

Other materials:

Knee Bolster Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. j. ...

Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction If the control valve body and oil pressure switch are replaced, always perform the initial learning. If the initial learning is not completed, engine rev-up may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial learning has not been implement ...

Panel Light Control Indicator Alarm
Purpose The panel light control indicator alarm notifies the driver that the panel light brightness is either at maximum or minimum. Function If the panel light control switch is in the maximum rotation position right or left when the TNS switch ON signal (TNS and headlight ...