Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Motor Mounts

Crankshaft, Main Bearing
Purpose, Function The crankshaft converts the reciprocating movement of the piston to a rotational movement via the connecting rod. The main bearing forms an oil film on the outer su ...

Engine Mount Disassembly/Assembly
No.1 Engine Mount (2WD) 1. Remove the front under cover No.2.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 1 No.1 engi ...

Other materials:

Hood Release Cable Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light (LH). c. Front mudguard (LH). d. Hood release lever. 3. Disconnect the hood release cable from the hood latch. 4. While pressing the tabs of the clip in the direction o ...

Automatic Transaxle Fluid (ATF) Replacement [Fw6 A EL, Fw6 Ax EL]
WARNING: Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury. 1. Remove the front under cover No.2.. 2. Remove the dipstick securing bolt. 3. Remove the dipstick. 4. Remove the drain plug and washer, and drain the ATF ...

Rear Door Trim Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 2. Remove the screw C. 3. Remove the cover D, then remove the screw E. 4. Take the shaded area shown in the figur ...

© 2016-2026 Copyright www.mcx5.org