Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Vanity Mirror Illumination Inspection

Mazda CX-5 Service & Repair Manual / Body / Lighting & Horn / General / Vanity Mirror Illumination Inspection

1. Disconnect the negative battery cable..

2. Remove the sunvisor..

3. Verify that the continuity between the vanity mirror illumination terminals is as indicated in the table.



Turn Light System
Purpose The turn light system flashes the turn light three times automatically according to the turn switch operation. The front body control module (FBCM) performs turn light system ...

Sensors, Switches, Relays
...

Other materials:

Cylinder Head Gasket Replacement
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakag ...

Crankshaft Position (CKP) Sensor Inspection
Visual Inspection CAUTION: When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing. ...

Side Garnish Removal
Front 1. Insert a tape-wrapped flathead screwdriver in the position shown in the figure, move it in the direction of the arrow (1) to remove the clip A. 2. Slide the side garnish in the direction of the arrow (2) shown in the figure and remove clips B from side garnish. 3. Remove clips ...

© 2016-2026 Copyright www.mcx5.org