Mazda CX-5 Service & Repair Manual: Navigation

Tweeter Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the side speaker grille.. 3. Remove the screws. 4. Pull out the tweeter and disconnect the connector. 5. Install in the reverse ord ...

Car Navigation System

Outline The car-navigation system displays point-of-origin and road guidance maps via the audio unit display and provides guidance and information to the desired point of destination. ...

Other materials:

Front Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Electronic Control Coupling
Purpose, Function An electromagnetic clutch, which operates smoothly due to the lack influence from the front and rear wheel traction force, has been adopted for the electronic control coupling system. Construction The construction of the coupling enables the torque formed ...

Relay And Fuse Block Removal/Installation
1. Remove the battery tray.. 2. Remove the air cleaner case.. 3. While pressing the relay and fuse block upper cover tab in the direction of the arrow (1) shown in the figure, lift up the relay and fuse block upper cover in the direction of the arrow (2) to detach the relay and fuse block up ...