Mazda CX-5 Service & Repair Manual: Ambient Temperature Sensor [Manual Air Conditioner]
Purpose
-
The ambient temperature sensor detects the ambient temperature.
Function
-
The ambient temperature sensor converts the detected temperature to an electric signal.
Construction
-
A thermistor-type ambient temperature sensor has been adopted.
-
The ambient temperature sensor is installed to the shroud panel on the back side of the front bumper.
Operation
-
The thermistor changes the resistance according to the surrounding temperature.
-
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.
Fail-safe
-
Function not equipped.
Ambient Temperature Sensor [Full Auto Air Conditioner]
Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric
signal.
Co ...
Blower Motor Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to blower motor terminal B, connect terminal
A to ground, and then verify its operation.
If there is any malfunction, replace the blower motor.
...
Other materials:
Rear Spoiler Removal/Installation
Removal
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
1. Remove the liftgate upper trim.
2. Remove caps A.
3. Remove nuts B.
4. Attach a piece of wire between the liftgate striker and liftgate latch to
ho ...
Steering SST
49 T028 3A0
Ball joint puller set
49 T025 001
Boot clamp crimpers
49 B032 317
Bearing & oil seal remover
49 B018 003
Body B
49 E032 308
Wrench
...
Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off.
2. Remove the clips.
3. Set the splash shield out of the way.
4. Disconnect the brake pipe from the LF brake hose.
5. Remove the clip.
6. Remove the LF brake hose from the bracket.
7. Detach the brake pipe from the pipe holder.
8. Install the SST ...
