Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Theft Deterrent Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). 3. Disconnect the connector. 4. Remove t ...

Door Lock Switch Inspection

Driver's Side 1. Disconnect the negative battery cable.. 2. Remove the door lock switch.. 3. Verify that the continuity is as indicated in the table. If the continuity is not ...

Other materials:

Rear Side Frame Removal [Panel Replacement]
Symbol Mark Removal Procedure NOTE: When drilling the 35 locations indicated by (A) and 4 locations indicated by (C) shown in the figure, do not drill a hole all the way through or there could be a problem when installing the new part. 1. Drill the 35 locations indicated by ...

Map Light Bulb Removal/Installation
Front Map Light 1. Disconnect the negative battery cable.. 2. To prevent scratches or damage, affix protective tape to the position shown in the figure. CAUTION: If a flathead screwdriver is inserted into the gap between the front map light and lens, the front map light could inter ...

Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The oil pressure switch detects the engagement pressures of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch. The oil pressure switch signal is used for automatic shift control, manual shift control, TCC control, line pressure control, direct electric ...