Mazda CX-5 Service & Repair Manual: Resonance Chamber
Purpose, Function
-
Pulsation of intake air is controlled and intake air noise is reduced by adding an intake air passage.
Construction
-
The resonance chamber is installed to fresh-air duct.
Plug Hole Plate Removal/Installation
CAUTION:
If the rubber on only one side of the plug hole plate front is lifted up,
it could damage the adapter at the location shown in the figure. When removing
the plug hole plate, lif ...
Valve Mechanism
Outline
A DOHC type valve system has been adopted and consists of four valves (two
intake valves and two exhaust valves) per cylinder for a total of 16 valves
operated by two camshafts.
...
Other materials:
PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “BSML” or “BSMR”.
3. Select the applicable PID from the PID table.
4. Ve ...
Up Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The up switch detects the shift up operation of the selector lever.
The up switch signal is sent to the TCM via CAN and is used for manual shift
control and engine-transaxle integration control.
Construction
The up switch is installed to the selector l ...
Auto Leveling Sensor Inspection
1. Disconnect the negative battery cable..
2. Remove the auto leveling sensor..
3. Prepare three dry cell batteries (1.5 V).
4. Connect the three dry cell batteries in a series.
5. Connect the positive pole of the dry cell battery to auto leveling sensor
terminal C, and the negative po ...
