Mazda CX-5 Service & Repair Manual: Parking Brake

Rear Brake (Disc) Removal/Installation

1. Loosen the adjusting nut.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. After installation, add brake fluid, bleed the air, and inspect for fl ...

Front Parking Brake Cable Removal/Installation

1. Remove the front console box.. 2. Remove the shift lever knob. (MTX). 3. Remove the shift panel.. 4. Remove the upper panel.. 5. Remove the rear console.. 6. Remove in the order indicated ...

Other materials:

Relay And Fuse Block Disassembly/Assembly
1. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 2. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull up relay and fuse block No.1 in the direction of the arrow (2) shown in the figure, and de ...

Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The oil pressure switch detects the engagement pressures of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch. The oil pressure switch signal is used for automatic shift control, manual shift control, TCC control, line pressure control, direct electric ...

Oil Pressure Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes. ...