Mazda CX-5 Service & Repair Manual: Rear Parking Brake Cable Removal/Installation
1. Remove the front console box..
2. Remove the shift lever knob. (MTX).
3. Remove the shift panel..
4. Remove the upper panel..
5. Remove the rear console..
6. Loosen the adjusting nut.
7. Remove the floor under cover No.2..
8. Remove in the order indicated in the table.
9. Install in the reverse order of removal.
10. After installation, inspect the parking brake lever stroke..
|
1 |
Nut |
|
2 |
Nut |
|
3 |
Bolt |
|
4 |
Nut |
|
5 |
Rear parking brake cable (See Rear Parking Brake Cable Removal Note.) (See Rear Parking Brake Cable Installation Note.) |
Rear Parking Brake Cable Removal Note
1. Remove the rear parking brake cable from the front parking brake cable..
2. Remove the rear parking brake cable from the rear caliper.
3. Remove the rear parking brake cable.
Rear Parking Brake Cable Installation Note
1. Install the rear parking brake cable to the rear caliper.
2. Verify that the outer end tabs of the rear parking brake cable is securely engaged with the bracket.
Parking Brake System
Outline
A center lever type parking brake has been adopted, improving operability.
Serviceability has been improved by enabling adjustment of the parking brake
lever from the vehicle ...
Parking Brake Switch Inspection
1. Disconnect the parking brake switch connector.
2. Verify that the continuity is as indicated in the table.
If not as indicated in the table, replace the parking brake switch.
...
Other materials:
Shift Solenoid No.1 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
Shift solenoid No.1 adjusts the hydraulic pressure in the low clutch circuit
based on the current demand from the TCM according to the vehicle conditions.
Construction
Shift solenoid No.1 is installed to the solenoid control valve body.
Shift solenoid ...
Owner Maintenance Precautions
The owner or a qualified service technician should make these vehicle inspections
at the indicated intervals to ensure safe and dependable operation.
Bring any problem to the attention of an Authorized Mazda Dealer or qualified
service technician as soon as possible.
When Refueling
• Brake ...
High Pressure Fuel Pump Inspection
NOTE:
The following vacuum values are indicated by relative pressure from the fuel
pressure sensor.
1. Verify that the fuel pressure sensor is normal..
2. Connect the M-MDS to the DLC-2.
3. Switch the ignition ON (engine off).
4. Select the “FUEL_PRES”, “LOAD” and “R ...
