Resistance Inspection
1. Remove the KS..
2. Measure the resistance between KS terminals A and B.

If not as specified, replace the KS..
504—616 kilohms [10—30 °C {50—86 °F}]
Intake Air Temperature (Iat) Sensor
Knock Sensor (Ks) Removal/InstallationDrive By Wire Control
Outline
Calculates the optimum target throttle valve opening angle at all engine
speeds and controls the throttle valve actuator.
The drive-by-wire control is composed of the idle air control, accelerator
control, traction control, excess engine speed control, overspeed control, ...
Hydraulic Variable Valve Timing Control
Outline
Changes the exhaust valve timing according to engine operation conditions
to improve engine output, fuel economy, and emission performance.
Based on each input signal, the PCM determines the optimum exhaust valve
timing according to the engine operation conditions. The P ...
Crash Zone Sensor [Standard Deployment Control System]
Purpose
The crash zone sensor detects an impact during a frontal or frontal offset
collision to the vehicle.
Function
The crash zone sensor converts the detected impact to an electrical signal.
Construction
The crash zone sensor is built into the clutch sensor.
...