Mazda CX-5 Service & Repair Manual: Knock Sensor (Ks) Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the intake manifold..
4. Disconnect the KS connector.
5. Remove the KS..
6. Install in the reverse order of removal.
KS Installation Note
-
Verify that there is no foreign matter caught between the KS unit and cylinder block.
-
The direction of the KS connector is within the 90-degree angle range shown in the figure.
Knock Sensor (Ks) Inspection
Resistance Inspection
1. Remove the KS..
2. Measure the resistance between KS terminals A and B.
If not as specified, replace the KS..
Specification
504—616 kilohms [10â ...
Knock Sensor (Ks)
Purpose/Function
Detects abnormal combustion in the cylinder as basic information for mainly
determining the ignition timing.
Detects abnormal combustion in the combustion chamber an ...
Other materials:
Floor Under Cover Removal/Installation
1. Lift up the vehicle.
2. Remove bolts A.
3. Remove fasteners B.
4. Remove the floor under cover No.1.
5. Remove nuts C.
6. Remove fasteners D.
7. Remove bolts E.
8. Remove the floor under cover No.2.
9. Remove bolts F.
10. Remove the fastener G.
11. Remove the floor ...
Front Map Light
Purpose
The front map lights shine light at the front of the vehicle interior.
Function
The front map lights illuminate when the map light switch is turned on.
Illuminates according to the lock condition of the driver's door and open/close
conditions of the doors u ...
Ambient Temperature Sensor [Manual Air Conditioner]
Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric
signal.
Construction
A thermistor-type ambient temperature sensor has been adopted.
The ambient ...
